Configuring Telnet session
Consider a topology:
In this topology we are going to access the CLI of Router0 using PC0
Configuring PC0:
Configuring Switch0:
interface FastEthernet0/1 switchport mode access
Configuring Router1:
interface GigabitEthernet0/0/0 ip address 192.168.1.1 255.255.255.252 no shutdown interface GigabitEthernet0/0/1 ip address 192.168.2.1 255.255.255.252 no shutdown
Configuring Router0:
interface GigabitEthernet0/0/0 ip address 192.168.2.2 255.255.255.252 no shutdown
Configuring Telnet on Router0:
enable password cisco line vty 0 4 password cisco login
Configure default route on Router0:
ip route 0.0.0.0 0.0.0.0 192.168.2.1
Router0’s routing table:
show ip route
Now, we can access Route0’s CLI using PC0.
On PC0’s terminal execute the command:
telnet 192.168.2.2
After this you need to enter the line vty password which is Cisco in this case.
Now, checking the changes on Router0:
Process of Using CLI via a Telnet Session
TELNET stands for Teletype Network. It is a type of protocol that enables one computer to connect to a local computer. It is a used as a standard TCP/IP protocol for virtual terminal service which is given by ISO. Computer which starts connection known as the local computer. Computer which is being connected to i.e., which accepts the connection known as remote computer. When the connection is established between local and remote computer. Telnet is a layer 7 protocol (protocol number 23) that is used to remotely access a device. You can learn more about it here. To enable telnet on a device we must first add set up a password and also provide the line vty with a password. You can read more about passwords here.