FAQs to Create Bootable Windows/Linux USB using CMD

How to create a Bootable USB on Windows using Command Prompt?

To create a Bootable USB Drive on Windows using CMD, the following steps should be executed.

1. Open Command Prompt in Administrative Format.
2. Insert the USB Drive.
3. Select the Disk using the Diskpart command & others.
4. Format the USB Drivers.
5. Create a Partition if necessary.
6. Make it activated using Active Command.

Will the USBs used for making Bootable remove every data?

Yes! The USE Device that will be used for making Bootable Pendrive along with any Operating System ISO file, will remove every content from the device. So, before going for the operation, they back up every data necessary in the device on another device.

Is it secure to make a USB Bootable Device?

Yes, it is completely secure to make a USB Bootable Device for any certain Operating System ISO File. From the device perspective, there will be no issues. Unless you downloaded a Spam ISO file from a third-party website that can cause issues to your pendrive as well as the device where you will insert it.

A Bootable USB is a disk that is used to boot up a system for the installation of an Operating System. If you want to use any particular USB Driver for Installation of any operating system, there is a need to make it bootable along with the ISO File of the OS. To Create a Bootable Windows/Linux USB, there are some methods present.

However, the Creation of Bootable USB Software could be easily achieved with Command Prompt or Terminal. A Bootable USB Windows can be made using a command line only for systems that have Higher Versions of Windows (7/8/8.1/10). Early versions of Windows i.e. before Windows 7, can’t be used for making a Bootable Windows/Linux Pendrive.

In this article, we will discuss the necessary steps required to Make a Bootable Pendrive for Windows or Linux using CMD in no time.

Quick Preview of Steps to Create Bootable USB using CMD:

1. Launch CMD in Administrative format.
2. Enter the Pendrive to the device.
3. Find out the Disk Name using commands.
4. Select the USB Drive file and format it.
5. Make it ready using the Active command.