How are These Tests Done Review- Alpha/Beta Review?
Destructive testing includes many activities such as designing a set of test scripts, executing test scripts, raising errors, closing errors, and providing metrics for success or failure to stakeholders at the end of iteration.
For a destructive test, there are many ways in which it can be tested. Let’s see some examples –
- Failure Point Analysis Method –
This is a detailed tour of the system that assesses errors that can occur at different points. For this strategy, help can be obtained from BA (Business Analyst). - Peer Testers Review –
This test is performed by a fellow tester to analyze the test cases and review those who are less familiar with the system/function. - Business review of test cases –
End users or experts may think of many valid scenarios that testers may not think about or miss because their focus will be entirely on testing requirements. - Take an Exploratory Test Using Run Sheets –
An Exploratory Test using Running Sheets will help determine what is tested, repeat tests, and allow you to control your test coverage.
Destructive Testing in Software Testing
Destructive Testing :
A Destructive test is one type of software testing similar to Bebugging in Software Testing. As in the Bebugging process, we add some known bugs into the software and monitor the rate of detection of errors. Similarly in Destructive testing, different points of failure in the software program are detected. With the help of this test, an application is intentionally performed to fail so that the robustness of the application is checked as well and various points of failure are also identified. As we know different types of software testing methods verify the performance of software, stability of software, compatibility of software, security of software, etc. Like by destructive testing we check the unwanted and unpredictable abnormal user behavior within the application.
Table of Content
- Importance of Destructive Testing
- What did it Achieve in this Test?
- How are these tests done review- Alpha/beta review?
- Methods of Destructive Testing
- Techniques of Destructive Testing
- Advantages of Destructive Testing
- Disadvantages of Destructive Testing
- Conclusion
In Destructive testing (or Destructive Physical Analysis, DPA) sample failure tests are performed, to understand the performance of the sample or the behavior of the materials under various loads. As compared to non-destructive tests these tests are usually much easier to perform and also easier to interpret. The destructive test is most appropriate, and economical, for things to be mass-produced, as the cost of destroying a few samples is negligible. Usually, this test procedure is not economical since only one or very few items are produced (for example, in the case of a building). The destructive failure mode is often analyzed and documented using a continuous high-speed camera recording (film loop) until the failure is detected. Failure can be detected with a sound detector or barometer that produces a signal to operate the high-speed camera.
The important thing is that even if you do not know the original requirements of a software product then also destructive testing can be performed. However, some knowledge can help develop a good testing strategy.