Working of Clipper
Using a Clipper means picking out parts of the input waveform and removing them. This is done by using diodes to make a small drop in voltage. This stops the signal’s strength from being too high. Here is a general explanation of the working of a clipper:
- Diode Operation: Clippers often use diodes to manage electricity flow. Diodes let current flow in one way only. In simple terms, a clipper uses this feature to control the size of waveform peaks.
- Series and Shunt Configurations: Clippers can be set up in line or side by side (parallel) with the input signal. In a series clipper, the diode is linked with the signal path in line. This lets it chop up waveform when power gets over some limit value. In a type of clipper called a shunt, the diode is linked to help with how electricity flows if there’s too much voltage.
- Threshold Voltage: The main thing in a clipper is the voltage limit. This is the amount of electricity needed for the diode to begin letting it move, which helps control how big or small a signal can be. The starting voltage decides when the cutting action happens.
- Clipping Action: When the waveform of input gets bigger than a certain point, it causes the diode to start flowing. This makes going from one side to another in low resistance easy for that signal. This makes the high-voltage part of the waveform smaller by directing it away through a special type of electronic device called a diode.
Difference Between Clipper and Clamper
Clippers and Clampers are very important for changing waveforms into different shapes. They are important parts of handling signals, helping engineers to manage and change electrical messages. A clipper is a simple electric system made to change the shape of an incoming sound wave. It controls or “clips” how loud it can be, so we don’t need full strength from start to finish. A clipper’s job is to take out or handle certain parts of a signal when it goes above or below a set limit. On the other hand, a clamper is an electronic part made to put DC (steady current) into AC (changing current). A clamper’s job is to move the whole waveform higher or lower without changing its shape.
Table of Content
- What is Clipper?
- Working of Clipper
- Types of clipper
- What is Clamper?
- Working of Clamper
- Types of Clamper
- Clippers and Clampers using Op-Amp
- Difference Between Clipper and Clamper